18mm*12mm Aluminum Textured/OP Reflector for Cree LED Emitters (4-Pack)

Pros: has a nice spot, but (see cons)
solid aluminum

Cons: bright spot only if you place a spacer between LED and reflector

Other: go for it
place a spacer between LED and reflector

Pros: These reflectors are surprisingly good. I use 4 in my M*glite with 4x Cree XRE emitters, I think 5 would fit in a circular pattern. Its the same reflector that came with my EDC 18650 light SKU 29096. With the reflector placed all the way down on the led it produces a very tight hot spot and long throw. If you put a rubber O ring around the emitter to lift the reflector so the bottom of it is near the top of the LED, then it produces a very large hot spot with bright spill good for making flood lights. The beam is fairly smooth in either case, in the 4x M*G with the reflectors lifted its like liquid gold. In the single emitter light I added light defuse film to get a perfect beam.

Cons: These should come with those little round sticky rings to insulate the reflector from the led/wiring. You would likely short out your light if you do not use some type of insulation ie tape rubber or at least cardboard.

Other: For the money they are great. The beam quality is better that what you would expect from a cheap reflector. If you are willing to work with them a bit about any beam, throw, flood, or something in between is achievable.

Pros: - Solid build quality, very strong
- Texture is nice, give a nice flood pattern
- the inside of the reflector is clean, no scratches and doesn't appear to scratch too easily either (though it would be very difficult to stratch it given it's size
- Excellent price considering you get 4 of them

Cons: - The bottom of the reflector is very dirty, but this is probably from where they were stuck down to be sprayed. So not really an issue.
- The hole is just too small to fit over an XM-L T6 bare emiiter (the little board the LED emiiter sits on....NOT the PCB). Again not an issue, just be nice as it's easier to balance and glue down that way.

Other: Great price, good build quality, good performance. Couldn't be happier!

Pros: The quality is very high.
It's a small aluminium orange peel reflector. Yes, it's aluminium, not plastic.
Individually wrapped.
Ideal for flood flaslights.

Cons: Nothing serious.

Other: Four piece for five bucks, it's a good deal. Buy it.

Pros: A good fit to the SKU 14598 1000 lumen XMLAWT LED. I have bought this reflector before and have fitted it to both the 1000 lumen XMLAWT and the 700 lumen P7 LEDS. You need to drill or file out the central hole to fit the P7 LED. All 4 came in their own plastic bag for individual protection, and then those 4 bags were placed into one slightly larger bag. The reflector surface is slightly mottled which helps to diffuse the beam. Solid aluminium so very rugged and helpful in conducting a bit of heat away from the LED. Either LED gives a good strong and bright centre about 1m wide at 2m distance. There is some gradual spill beyond that, it isn't a sharp edge, but the spill is not overly useful as the bright centre is so dominant. At distances further away the lighting effect is awesome when used with the 1000 lumen XMLAT LED.

Cons: None.

Other: Good reflector and cheap. Well worth the money especially when you get 4 in a packet.

Pros: good reflector, good spot depending on how you position it from the led. cheap

Cons: don't touch the reflective surface, it will mark and if you attempt to clean it it will make things worse if you want the max light coming out of the front you will have to drill holes for the solder connections to sit in. need to insulate from led contacts

Other: good reflector if you don't mess up the surface.