High Performance DC Brushless Cooling Fan for PC Video Card

Pros: Fits my Radeon HD2600PRO just fine. Temps are about 5 degrees celcius less than stock cooler. A lot of surface area to disipate heat. Quiet.

Cons: Somes of the fins were bent during shipping. Very poor lap job on bottom of heatsink. Takes up two expansion slots.

Other: A good buy for the price. Wouldn't use on a high-end card, but will work just fine for mid- or low-end cards. Beware, will take up two slots.

Pros: It was cheap, excellent build quality for the extremely low price, and was free shipping. It cools the card by like, 10-15 degrees on average. very good!

Cons: It was slightly out of kilter for my card, but I use my awesome, totally sweet powers of improvisation, and made it fit on my card, and it cools it several degrees cooler. A couple of the fins were slightly bent, but not enough to matter.

Other: Good value I would buy it again. without qualms. I like how it looks, and it is really cool.

Pros: Really Cheap Cooler, Cools relatively well. Not Too Big. Relatively Quiet

Cons: Build quality loses points because of the bent fins that came when in shipping. Lapping took me an extra 10 minutes as well, since i was able to play music with my fingernail.

Other: Good Product. The first one i received came with a missing pin, but Dealextreme's customer service is REALLY Excellent. It also took a while to arrive, but no matter. the product works.

Pros: This fan makes an excellent replacment for a video card where the original fan has burnt out. This fan fitted perfect on my sapphire radeon X1650 pro. Its very quiet And cheap

Cons: The build quality could be better i.e could be smoother on the underside Because you can see marks where the alluminium has been machined packing was ok but still one of the fins was bent out but it was easy to bend back. It should come with some thermal heat sink compound a bit bulky it covers up a pci slot on my mother board

Other: Don't spend more money on a new card buy this to fix your existing one Remember to get heat sink too

Pros: Really quiet - before my GFX card had a stock fan and that was the nosiest part of my PC - now it's my processor chip fan, and that is pretty quiet already!
Easy to fit, has a nice wide fitting range - but should fit most gfx card with have 50mm spacing for the fan connectors.
Has a 'small' 3v connector - my gfx card had both sizes, so check your card. That said - I didn't notice the smaller power supply at first, so i simply removed the pins from the female part of the fan and stuck them directly on to the pins.
Nice wide heat transfer area.
Using Riva gfx monitor I see my average standing temp has dropped from 61c to under 55c - but also added new heat transfer grease at same time.

Cons: Erm, none.

Other: Cheap - quiet - cool.

Pros: The cooler is cheap and seems to be able to fit on a variety of cards. It's also not very noisy and can sufficiently cool lower end videocards.

Cons: The base of the heatsink was rather rough, and several fins were bent during transport. The installation with pushpins is also not the best, but it does the job. Don't expect it to have enough cooling capacity to cool high end cards, but it'll do for cards that use less power.

Other: This heatsink does the trick to replace the cooling of cards with broken fans. Don't expect it to be the quietest or best cooling solution ever and you'll be pleased.

Pros: Bough it to replace a dead cooling fan of a Radeon 9600 Pro. It's quiet and I got no hickup, artefacts or any heat related problems with this new cooling fan. This cooling fan fitted well on my old Radeon 9600 Pro without any need to modify it.

Cons: Nothing.

Other: I will buy another if ever I need a fan for another VGA card. I really good value for my money.

Pros: -Nice fan, I used it to replace passive cooling on my gfx card.
-Pretty straightforward to install, however it required some fiddling.
-Pretty quiet.
-Lowers temps pretty decently.

Cons: -I needed to solder on another fan connector. No matters for me though, I'm used to stuff like that.
-The push-connectors move pretty stiff, which makes it somewhat hard to install.
-Good thing I ordered 2, because one looked like someone stamped on it. (Easily bent...)

Other: It's a good product, but has some quirks and you're better off ordering 2 from the get-go to make sure they arrive in (near) working order.

Pros: Good value - it is a functioning fan with heat sinks for cheap
Seems quiet - no issues so far

Cons: Some fins were bent when I received my package - was annoying but I fixed it by bending it back. There was no performance loss on it
Dust is getting stuck in the fins which is expected but still annoying
Holes didn't fit my FX560, but some cable ties seem to do the trick

Other: Does the job! Would buy again!

Pros: This fan has a huge heat sink attached to it which is cools down my graphics card significantly. This fan also runs quietly and spins pretty fast. After running my graphics card for a while and the card is cool-warm to the touch compared to previously, hot.

Cons: The connector that came with it is smaller. So i had to cut it off and solder my old one on. Some of the heat sink fins were arrived bent, but were easily bent back to shape.

Other: If you need a cooling effective, silent fan, get this.