P6060 Oscilloscope Probes - Pair (120cm Length)

Pros: These are very good quality probes. Well made Good clear waveforms with no distortion that you can sometimes get with cheap probes.

Cons: None

Other: Recommended

Pros: 1:1 or 1:10 Good tips Very flexiable cables. Color marking rings.

Cons: It looks cheaper than probes I can buy in local stores for more than twice price, so it's not realy a con.

Other: I didn't measure signals more than 5 MHz(my oscilloscope doesn't let me get higher frequencies), so I don't realy know how it works above this frequency, but it works very good from 0Hz to 5MHz. So if you need to measure e.g. audio frequencies I assure you youcan buy these probes without any doubts.

Pros: Ergonomic and esthetic design. Acceptable quality (please see cons). Good calibration range make it suitable for alemost all popular osciloscpoes.

Cons: In some items the hole in casing is not exactly concentric to the calibration trimmer what makes the calibration proecess not as convenient as it should be. The colorfull marking rings seem to be a little bit too small. When assembled on the probe have the large gap on circumference that could be smaller (for better ring visibility). I use four probes at the same time so good marking is important too me. When using only one probe the marking doesn't matter.

Other: TOpinion based on tests up to 10MHz for now.

Pros: Good probes considering the price. With the scope set to 20mV and up I could not see any distortions. In the range 5-10mV a small distortion is visible. I These probes seem to be better than SKU32422, SKU34220, and SKU34221, based on some basic low frequency testing.

Cons: I was not able to compensate for the distortion using the screw, even though my scope wants 20µF, and the compensation range of these probes are 15-45µF.

Other: Cheap. Good enough. Go for it.

Pros: Very good value for price, quality above average. The product is one third cheaper than electronics stores in my country. The product comes with a manual in English, with useful instructions for setting frequency compensation.

Cons: None

Other: I got a very good product for this price category

Pros: Came in storage bag Came with manual Ground clips can be removed and therefore extended or replaced! Colouring rings for easy knowing which probes go where Came calibrated Came with calibration tool The probes looks like they may be cabaple of the specs!

Cons: Cables are very thin, dunno how long it will last, hopeful longer than the last ones

Other: Looks like one of the better/priceworthy probes you can get from DX

Pros: I realy surprise with the good quality I found in this product. But had no time yet to have a precision measure to make using this probe. But is not a problem as I will buy a spare part and will have another chance to leave my comments here.

Cons: The only cons I found is these probe cable is made only 15 cm short that parts that i have bought before. these short cable can be a problem in my use of labor day.

Other: Advice to make to take out scorpion of their pockets and make a cable with little longer measure.

Pros: This probes should be in every electronic hoobbyist's tool bag (along with an actual oscilloscope, of course)! I've bought this for my SKU93518 cheap USB oscilloscope (USBee AX clone), due to it's low input range (-10 to +10V); the x10 range on the probes allow me (theoretically) to measure a higher signal (almost -100 to +100V). The technical specs are appropriate for hobby use (don't expect it to excel like the $200+ probes); but what can you expect at a price similar to a professional oscilloscope carrying bag?

Cons: None so far. The probes are doing their job perfectly (at a maximum tested frequency of 4.9MHz @5V, at least).

Other: Perfect for hobby use!