Repair Parts Replacement Buttons for PSP Phat/1000 (Black)

Pros: I found that these buttons were exactly what I was looking for. We had taken my sons PsP apart over a year ago and lost a few of the buttons because it was apart in a cupboard. These buttons were the perfect solution to our problem.

Cons: Had to fit a couple of the so that they didn't stick. If you take the time to make sure they press without sticking, then you will have no problems in the long run. So take the time to fit them to your PsP before you put them in and close your PsP.

Other: Buy them, they are cheap and worth what you pay. You can't go wrong. I would buy them again.

Pros: -Exactly like the original -buttons looks very well done -Good replacement if you lose or broke the button -no other comments just that it's looks exactly like the original.

Cons: -Could be cheaper consider the price -My home strip was bend and it look like it was broken, it wasn't but the bend will mean it will be harder to fit the strip into the psp faceplate. -Doesn't come with the glue that the original home strip have. -The direction button is abit smaller than the original but still fits perfectly.

Other: Said almost all i can about the buttons, it's just a button, 500 words is really too much for a button, should i spam?

Pros: It is very cheap, that's about it

Cons: buttons are "sticky", i had a issue with them rubbing and sticking

Other: Buy it if you need a new D pad, or a new home button thingy, otherwise I would go with another company, these are ungodly cheap, also it seems like the markings will wear off of the buttons, the originals had clear plastic over the button marking, these replacement ones just have the marking on the surface

Pros: 1. Worth the price as genuine buttons are very rare and overpriced if found!
2. Build quality is OK, but may have some rubbing, sticking, etc with the faceplate.

Cons: 1. Certain buttons (in my case, the 'HOME' button) sticks if the faceplate is tightened completely. To remedy this, I have loosened the faceplate a tiny bit.
2. The printed logos (/\, [], 0, X) are not dead centered. This is not obvious, but apparent if closely inspected.
3. The buttons are not 'Crystal' like the genuine ones but black lacquered buttons with the logos (arrows & /\, [], 0, X) in dull grey.

Other: This button set is well worth the price and essential if you are repairing PSP consoles. Get them while they last!