Universal Nylon Mount for Flashlights and Lasers

Pros: Really good little gadget, does exactly whats required and keeps torch, laser tightly attached to the scope so accuracy is maintaned etc.

Cons: Would be better if the velcro attachments were opposite each other so the straps could be left intact without the need to cut them to size or try and hide the excess out of the way

Other: For the price this is a great little item and i'm glad i found this. Simple to use and well made, the rubber mount can accomodate most size scopes / guns as it bends to various sizes therefore keeps tightly fitted

Pros: GREAT ITEM!!! ITS 2.50, and I would gladly pay $5 for it.
-Made of this flexible Rubber Stuff, not stiff plastic (clings on to stuff better, especially good if you are mounting on something not perfectly round, or if what you are mounting on is bigger or smaller than the actual diameter of the grip)
-TIGHT hold
-Will not slip
-LIGHTWEIGHT!!
-CHEAP AGAIN!!
-Holds everything Extremely tightly, This includes the "True 30mW green laser", and other pen laser, Flashlights (MXDL's, and others), Flashlight style lasers, and much more!

Cons: No instructions, took me a second or two to figure out which way and how the velcro was fastened (you need to pull the velcro end that has no Plastic rectangle (the rougher part, not the softer velcro part) all the way until the Plastic rectangle touches the actual base of the mount. Then you thread the velcro though and stick it on.)

Other: GET IT!

Pros: Cheap
Reasonably simple to use.
Rubber in the middle secures very nicely!

Cons: Velcro is a bit fiddly, and a little long, occasonally
Rubber block could be wider...
Should come with straps opposed (see below)

Other: If you have a flashlight and something else, buy this. It's cheap!

Pros: Great little gadget, tightens both ends to grip your torch, or whatever you wish to put in there!
Even mounts on my helmet so I can shine my lights where ever i point my face!

Cons: no, one one, none, nadda, zip, zilch, zero!

Other: The reason I bought two is because If i bought one i'd have to mount it on the top of my head (to retain balance) and with the amount of branches and trees and stuff that jumps out at you in the night, I personally wanted them down low!
BUY, FIT, RIDE!

Pros: Price is great. Very useful little gadgets. I'm using mine to mount flashlights on my bike helmet - like many others. For this purpose these are just perfect. Hold any sized flashlights (within reason) very securely.

Cons: None really. I only wish I could get some like these at right-angles so I could use them to mount lights on my handlebars as well (PLEASE DX!). That would be better than sku.8274 which are not bad.

Other: For mounting lights on your bike helmet, these are perfect! Let's have some right-angled ones available sometime :)

Pros: + Can attach your flashlights and laser pens
+ It is made of rubber material which holds on to your flashlight securely without slipping off
+ Nylon straps are long enough for most flashlights, even if one has a big diameter (provided that it fit the mount)

Cons: - Nylon straps are too short to fasten on my small wrist, not to say arm; so the photo is misleading

Other: This is a good mount not just for flashlights but anything that can fit it. Velcro your flashlight securely and you are good to go.

Pros: - This is a great little mounting bracket.
- Well built, velcro is a good length and
plastic clips seem strong.
- Fits well through the slots in our bike
helmets.
- Can't feel the velcro strap on our heads
from inside the helmet.
- Price is unbeatable.

Cons: absolutely none.

Other: If you're looking to mount a cree flashlight on your bike helmet then this mount could be really useful. One risk you run is that your helment might not have slots that will give you the right angle, but for the price why not give it a go anyway?

Pros: Very simple device with good build quality. I use it for my laser on my paint ball gun. Once I get my Cree Q5 and P7 flashlight from DX, I am going to try it on my paint ball gun.

Cons: At first glance, it seems very easy to use but it can be a little confusing. An instruction would have been helpful.

Other: For the price, you can't go wrong. I may get a few more.

Pros: This is an amazing product!
-I can put on my helmet
-I can put on my arm
-Very wide area to stretch to
-It can go on a gun or a paintball gun.

Cons: Only one con
-"Very wide area to stretch to" maybe too wide. I had to tape it so it would not stick out. Or you could just cut the excess.

Other: A great product and durable. But if you want to go on your paintball barrel, you might have to cut off some of the excess. I just ended up taping the excess with duct tape. But I am thinking of cutting off all of the excess.

Pros: I wasn't quite sure how much use I would get out of this when I bought it, but I was pleasantly surprised that it fit like a glove on my paintball barrel, and held my flashlight to it perfectly. Works great for scenario games and i suppose for home defense... and it looks awesome. The holder keeps things very snug.

Cons: None really... at least not for my purposes. Keep in mind the size of the (rubber?) holder on each side for whatever you plan on using it for.

Other: Probably one of my best buys on DX for the price and the use I am getting out of it. Buy it!