USB FMS Simulator Cable for Futaba and ESky Remote Controllers

Pros: -Cheap -Plug 'n Play -Small -Works on lots of transmitters

Cons: -Didn't work on my Walkera transmitter, the cause of this problem was my tranmitter, it didn't put out the right signal on it's trainer port, i opened the transmitter and is soldered the trainer port to one off the decoders pins where the right signal come out.

Other: If you have a transmitter lying around, be sure to order one of these, good for hours and hours of funm, also good to practice flying.

Works with the following controllers (tested)
-Field Force 9
-MX-12
-all multiplex
-transmitter that comes with graupner 47G heli

Pros: - Super Ultra Cheap
This one is cheaper then the other cable presented and with the 3 different adaptors I don't even see the difference!
- I use it for Esky and Futaba Controllers
- It Works!

Cons: - Only 4 channel support
- To make it work you have to fight against many obstacles as the manual is not helpful

Other: Nice flying in simulator you can train to avoid too much crashes.

Pros: Works great... as long as you have a TX it will connect to.
I've tried it with both JR & Futaba TX's

Cons: ****Doe's not come with a plug suitable for Multiplex transmitters****
Which is a shame as I bought it for my new Cockpit SX.

Other: If you've got a JR or Futaba TX & only need to use 4 channels, then this is perfect.

Pros: Very easy to use, plug and play. Just make sure that you have calibrated your new controller under joysticks.
There are three cable and plugs for several types of connection. I used square type futaba and it worked at first trial.

Cons: cheezy build quality only 4 channel. i wish that it would have at least 6 channel.
This means you cant cntrol flaps or gears or smoke or lights.

Other: go get it. easy to use and make you able to fly with your futaba branded radio over computer screen. very helpful for rookies.

Pros: Price. Number of adapter plugs. Works with my E_Sky, my Futaba, and Hitec transmitters.
Includes FMS on disk with tons of planes.

Cons: Cable could be a bit longer, but not a huge issue. As always, the wait for it to arrive.

Other: If you are in the market for an interface for you transmitter to your PC, do not hesitate.

Pros: - Driverless, just plug and use it
- Lots of adapters, makes it compatible with a bunch of rc transmitters
- Cable length is just enough
- Precise controlling
- 8 channel capable

Cons: - A damn red led that blinks on the dongle, man.. thats annoying, specially on darkness.

Other: I'm using on a Futaba t4vf, but I guess it fits any radio of any brand, as far as it runs on 72Mhz. RealFlight G4 + DongleEmu goes ok with the cable!

Pros: I bought this for my futaba 6exa transmitter. It has very simple setup. You need to set it up first then you need to calibrate through windows interface. use Joysticks.

Cons: Only 4 channel not 6.

Other: It is very good idea to practice if you are new to RC planes. I am not new but still fun to play when wind is fast outside. I am using Aerofly Deluxe. It works but without flaps or gears. only main 4 channels.

Pros: -Cheap, easy of use, build quality. I bought it for my E-sky 6-channel transmitter. Drivers aren't required for windows XP. Works fine with realflight G4.5 simulator. CD with FMS simulator. Cabel length is 1.5m, not too short. Can be connected to lots of RC-transmitters.

Cons: Outputs only 4 channels, not 6. Blinking red light.

Other: cheap price, quality, works fine. If you need it, Buy it :)
Sorry for my bad english, but i think you can understand it :)

Pros: Got it for my Blade 400 3D control, DX6i, to use it on computer games. it worked just fine, just some settings that were kind of complicated but the XP recognized the control without using the cd. very good.
Got it for my Blade 400 3D control, DX6i, to use it on computer games. it worked just fine, just some settings that were kind of complicated but the XP recognized the control without using the cd. very good.
Got it for my Blade 400 3D control, DX6i, to use it on computer games. it worked just fine, just some settings that were kind of complicated but the XP recognized the control without using the cd. very good.

Cons: No Cons, very good and acessible price

Other: there's a flashing light on the USB plug, I just connected on the back of the PC. it's quite a distraction especially when you're playing.

Pros: This is a perfect cable. At first I had some problems with my DX6i. There isn't any instructions or help. When checked on internet I find that, transmitter has to be at Airplain mode. When I switched to airplain this worked just fine.
Windows automaticly recognize and you has to do nothing. Just lunch the simulator. And enjoy.

Cons: Nothing really nothing, Connectors are tight and rigid. Every thing with cable is flawless. Thanks DX.

Other: This is a perfect cable. At first I had some problems with my DX6i. There isn't any instructions or help. When checked on internet I find that, transmitter has to be at Airplain mode. When I switched to airplain this worked just fine.
Windows automaticly recognize and you has to do nothing. Just lunch the simulator. And enjoy.